Operating The Spreader - Toro 34230 Operator's Manual

Figure 22
To turn left or right, move the steering control
toward the desired turn direction.
3. To stop the machine, move the motion-control
lever to the N
EUTRAL
Note:
Stopping distance may vary depending
on the spreader-sprayer load.

Operating the Spreader

CAUTION
Chemicals are hazardous and can cause
personal injury.
• Read the chemical manufacturer's
directions on the label before handling
the chemicals; follow all manufacturer
recommendations and precautions.
• Keep chemicals away from your skin.
Should contact occur, wash the affected
area thoroughly with soap and clean water.
• Wear eye protection, gloves, and any other
protective equipment recommended by the
chemical manufacturer.
Use the spreader to disperses free-flowing granular
substances such as grass seed, fertilizer, ice melt,
etc. When you use the spreader, first fill the granular
hopper, then apply the granular materials to the work
site, and finally clean the hopper.
Important:
When you use your spreader,
thoroughly clean it at the end of the day.
position.
Using the Spreader and
Information Display
Spreader Screen Icons
Spreader
g020126
Motor Overcurrent Error
Motor Wire Fault
Percent of Full Speed
Spreader Information Screens
•
Spreader Start-Up Screens (page 25)
•
Default Spreader Screen (page 26)
•
Sprayer Operation Screen (page 39)
•
Spreader Fault Codes (page 75)
Spreader Start-Up Screens
When the key is switched to the R
spreader and information display shows the following
screens, each for 2 seconds:
Note:
The LED status light changes from red, to
orange, and to green.
25
Off
Voltage Measurement Error
Motor Open Error
position, the
UN