Maintaining The Chassis; Checking The Machine For Loose Hardware - Toro 34230 Operator's Manual

Figure 99
1. Jam nut (pattern control cable)
2. Linkage rod
3. Impeller shaft
4. 1/8 inch (3.2 mm) gap between ramp tooth and impeller
shaft
5. Ramp tooth
6. Pull the linkage rod until there is 1/8 inch (3.2
mm) gap between the ramp tooth and the
impeller shaft (Figure
7. Tighten the jam nut
8. Adjust the spread-pattern-control handle; refer
to Adjusting the Spreader Pattern (page
99).
(Figure 99).
33).

Maintaining the Chassis

Checking the Machine for
Loose Hardware
Service Interval: Before each use or daily
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page
2. Visually inspect machine for damaged or worn
parts, and check for loose hardware.
Note:
Before operating the machine, replace
any damaged parts and tighten all loose
hardware.
g027205
71
57).