Sprayer Controls - Toro Multi Pro 5800-G Operator's Manual

USB Power Port
The 2-socket USB power port is located at the back
of the armrest.
Figure 12
1. USB port
g194424
2. USB sockets

Sprayer Controls

1. Application-rate switch
2. Pressure gauge
3. Spray-mode switch
4. Tank-agitation switch
5. Right boom-section lift
switch
6. Right-section switch
Pressure Gauge
The pressure gauge
dash. This gauge shows the pressure of the fluid in
the spray system in psi and kPa.
Spray-Mode Switch
Use the spray-mode switch to change between the
application rate mode (closed loop) and the manual
mode (open loop)
Application-Rate Switch
The application-rate switch is located on the dash
to the right of the steering wheel
the application-rate switch to control the spray pump
speed when operating the sprayer in the manual
mode. Press and hold the switch forward to increase
the application rate (pressure), or press and hold it
rearward to decrease the application rate (pressure).
21
Figure 13
7. Center-section switch
8. Left-section switch
9. Master section switch
10. Left boom-section lift
switch
11. Spray-pump switch
(Figure 13) is located on the
(Figure 13). Use
g195515