Sprayer Controls - Toro Spray Master Operator's Manual

Deflector Control
The deflector control (Figure
into the spreader pattern.
Diffuser Control
The diffuser control (Figure
placement of the impeller either to the edge of the
impeller or to the middle of the impeller.
Drop-rate Cam and Linkage
The drop-rate cam and linkage are located at the front
of the machine and below the hopper on the spreader
(Figure 9).
1. Slot–maximum position
Use the drop-rate cam to set the maximum amount of
granular material dispensed through the impeller gate
and onto the impeller.
The slot in the cam, after setting 9 on the cam,
allows you to open the impeller gate to the maximum
position. You can use this setting for dry sand, ice
melt, or other materials that are difficult to spread.
Note:
Use cam setting 9 may when you are cleaning
out the hopper.
8) pivots the deflector
8) shifts the product
Figure 9
2. Linkage

Sprayer Controls

1. Left boom spray-control
valve
2. Center boom spray-control
valve
3. Right boom spray-control
valve
Spray-Pump Switch
g027033
Push the spray-pump switch
turn on spray.
Push the spray-pump switch rearward to turn off spray.
Left Boom Spray-Control Valve
Push the left boom sprayer-control valve
to activate spray for the left boom.
Center Boom Spray-Control Valve
Push the center boom sprayer-control valve
10) to activate spray for the center boom.
Right Boom Spray-Control Valve
Push the right boom sprayer-control valve
to activate spray for the right boom.
Sprayer Pressure Gauge
The sprayer pressure gauge
pressure (in psi) while you are spraying.
Spray-Pump Foot Switch
Press and hold the spray-pump switch
turn on the spray.
Release the spray-pump switch to shut off the spray.
15
Figure 10
4. Sprayer pressure gauge
5. Spray-pump switch
(Figure 10) forward to
(Figure
(Figure
(Figure
(Figure 10) displays the
(Figure
g311620
10)
10)
11) to