Having Problems Sending A Fax - Konica Minolta bizhub 225i User Manual

10
10 If you suspect a failure then do the following
10.1

Having problems sending a fax

Fax status
The original is not scanned.
The original is scanned oblique-
ly.
An unclear image has been re-
ceived in a destination.
A blank image has been re-
ceived by the destination fax
machine.
Cannot send a fax automatical-
ly.
10-3
Major cause
Is the original too thick?
Is the original too thin or small?
Is the Original Glass dirty?
Does the Lateral Guide match
the original width?
Is the original positioned correct-
ly?
Is the Original Glass dirty?
Is the original text too faint?
Is there a problem on the line sta-
tus or destination fax?
Has the original been loaded with
the side containing the message
facing down? (in use of ADF)
Is the number correct?
Are you calling a telephone-ded-
icated number?
Is there a problem at the destina-
tion? (Paper out, Auto RX is dis-
abled, the power is not turned
off, and other causes)
Having problems sending a fax
Corrective actions
Load the original on the Original
Glass. For details, refer to [Us-
er's Guide Copy].
Load the original on the Original
Glass. For details, refer to [Us-
er's Guide Copy].
Wipe the Original Glass with a
soft, dry cloth.
Adjust the Lateral Guide to the
original width. For details, refer
to [User's Guide Copy].
Position the original correctly.
For details, refer to [User's Guide
Copy].
Wipe the Original Glass with a
soft, dry cloth.
Specify the scanning density.
(p. 7-21)
Make a copy on this machine to
check the result. If a copy image
is clear, send the fax again.
Load the original, ensuring that
the side containing the message
is facing up. Then, send the orig-
inal again. For details, refer to
[User's Guide Copy].
Check the number.
Check the number.
Check with the sender.
10.1
bizhub 225i