Changing Or Deleting The Polling Rx Program; Changing Or Deleting The Relay Instruction Transmission Program - Konica Minolta bizhub 225i User Manual

7
7.2.12

Changing or deleting the polling RX program

1
Press the Utility key.
2
Use the +/, key to select [DIAL REGISTRATION], then press the OK key.
3
Use the +/, key to select [PROGRAM DIAL], then press the OK key.
4
Press the One-Touch Dial Key that contains the polling RX program you want to change or delete.
5
Use the +/, key to select [EDIT] or [DELETE], then press the OK key.
% If [EDIT] is selected, go to the next step.
% If [DELETE] is selected, the information registered in the program dial is deleted, and the display re-
turns to the Store Address screen.
6
Use the +/, key to select [ADD] or [CHECK/EDIT], then press the OK key.
% If [ADD] is selected, enter a destination, then press the OK key.
% If [CHECK/EDIT] is selected, go to the next step.
7
Use the +/, key to select a target destination, then press the OK key.
% To delete the displayed destination, press the Clear/Stop key, then select [YES] in the displayed
screen.
% Repeat this procedure until checking and correcting a destination is completed. After this, press the
Back key.
8
Select [RETURN], then press the OK key.
This registers settings, and returns to the Store Address screen.
7.2.13

Changing or deleting the relay instruction transmission program

1
Press the Utility key.
2
Use the +/, key to select [DIAL REGISTRATION], then press the OK key.
3
Use the +/, key to select [PROGRAM DIAL], then press the OK key.
4
Press the One-Touch Dial Key that contains the relay instruction transmission program you want to
change or delete.
5
Use the +/, key to select [EDIT] or [DELETE], then press the OK key.
% If [EDIT] is selected, go to the next step.
% If [DELETE] is selected, the information registered in the program dial is deleted, and the display re-
turns to the Store Address screen.
6
When necessary, use the One-Touch Dial Key, Speed Dial, or Keypad to specify a destination, then
press the OK key.
7
If necessary, change the Relay User Box ID or password using the Keypad, then press the OK key.
This registers settings, and returns to the Store Address screen.
7-16
RELAY INITIATE
DESTINATION
Store Address 7.2
bizhub 225i