Loading The Original; Loading The Original Into The Adf - Konica Minolta bizhub 225i User Manual

3
3.2

Loading the original

The original loading methods are classified into two types: loading the original into the ADF and loading the
original on the Original Glass. Load the original in the appropriate method to fit the original type.
3.2.1

Loading the original into the ADF

1
Press the Fax key.
The machine switches to the fax mode.
2
Load the original into the ADF, turning up the side to be scanned.
% Up to 130 sheets can be loaded for A3-size plain paper.
% Do not load more than 130 sheets (21-1/4 lb (80 g/m
and do not load the sheets up to the point where the top of the stack is higher than the , mark.
Doing so may cause an original paper jam, original damage, or ADF failure. However, if the original
contains more than 130 sheets (21-1/4 lb (80 g/m
% If the original is 17 inches (432 mm) or more in length, only one sheet can be loaded.
% When scanning a 2-sided original, load it into the ADF, turning
the first page up.
3
Adjust the Lateral Guide to the original size.
% A custom-size original can be scanned up to the sizes shown below.
Width: 8-1/2 inch (210 mm)
3-5
2
2
)), it can be scanned separately.
*
to 11-11/16 inch (297 mm)
Loading the original
)) at a time into the Original Tray of the ADF,
3.2
bizhub 225i