Installing A New Driver - Canon iR3245 Network Manual

Installing a New Driver

1. Check the settings for <RX/Print Range> in [IP Address Range Settings] on
the IPv4 or IPv6 Settings screen to see whether the IP address of the
computer in which a driver is to be installed is permitted. For details, see step
8 in " TCP/IPv4 Settings (p.3-4) ," or step 6 in " TCP/IPv6 Settings (p.3-13) ."
If the settings for <RX/Print Range> in [IP Address Range Settings] on the IPv4 or IPv6 Settings screen do
not permit the IP address, you cannot install a driver.
If the IP address of the computer is beyond the range of the permitted addresses set for <RX/ Print
Range> after installing a driver, you cannot print or send a fax from the computer.
2. Install the driver.
Install the driver according to the following procedures indicated in the manual for each
driver:
If you want to use the UFR II/PCL/PS printer driver
See the procedure for dynamic installation in the Printer Driver Installation Guide.
If you want to use the fax driver
See the procedure for dynamic installation in the Fax Driver Installation Guide.
The print application will be LPD and the print queue will be set to <LP> if the driver has been installed
according to the above procedures.
This machine enables you to specify print queues other than <LP>. You can also use Raw as the print
application. For instructions on how to change the settings, see "Changing the Port after Installing the
Driver(p.3-84)."
Installing a New Driver
3
3-83