Canon iR3245 Network Manual page 33

Remark
When connecting the interface cable or network cable,
be sure to observe the following precautions to avoid
electrical shock.
Turn OFF the machine's main power switch before
disconnecting the power cord from the power outlet.
(See the Reference Guide.)
Turn OFF the computer and disconnect the power
cord from the power outlet.
You cannot use the machine as a repeater, bridge, or
gateway.
If two or more machines are on an AppleTalk network,
they should be switched 'ON' 10 seconds or more
apart.
The machine can automatically detect the type of
Ethernet (10Base-T, 100Base-TX, or 1000Base-T).
If you are using a mixed 10Base-T/100Base-TX/
1000Base-T environment, devices on the network
(hubs, routers, etc.) must support the mixed
environment. For more information, consult your local
authorized Canon dealer.
After connecting the network cable, perform the
following operations. (For more information, see the
relevant descriptions.)
Set the date and time, and System Manager
settings. (See the Reference Guide.)
Set the network settings.
Install a driver if necessary. (See Chapter 10,
"Before Printing from Computers," or Chapter 11,
"Before Sending Faxes from Computers," in Getting
Started.)
Install a utility if necessary. (See the manuals
provided with the utility.)
Connecting to a Network
2
2-5