Select [All IPv6 addresses] for <Remote Address>.
Applying a Security Policy to the IP Packets Received from and Sent to the
Specified IPv4 Address or IPv4 Network Address:
Select [IPv4 Manual Settings] for <Remote Address> → specify a single IPv4
address or range of IPv4 addresses. Also specify the subnet.
Applying a Security Policy to the IP Packets Received from and Sent to the
Specified IPv6 Address or IPv6 Network Address:
Select [IPv6 Manual Settings] for <Remote Address> → specify a single IPv6
address or range of IPv6 addresses. Also specify the IPv6 address and prefix
length.
6. On the Selector Settings screen, specify the destination port to apply the
registered security policy to.
When receiving IP packets, the registered security policy is applied if the destination port in
the packets matches the port number specified in this procedure. When sending IP packets,
the registered security policy is applied if the source port in the packets matches the port
number specified in this procedure.
Applying a Security Policy to the IP Packets Received from and Sent to the Local Port and
●
Remote Port Specified By Port Number:
Applying a Security Policy to the IP Packets Received from and Sent to the Port Specified
●
By Assigned Application:
Registering a Security Policy
3
3-63