Remote Node Configuration; Remote Node Setup Overview; Remote Node Setup; Remote Node Profile - ZyXEL Communications P-662HW-61 User Manual

802.11g wireless adsl2+ 4-port security gateway

Hide thumbs Also See for P-662HW-61:

Table of Contents

Remote Node Configuration

This section describes the protocol-independent parameters for a remote node. A remote node

is required for placing calls to a remote gateway. A remote node represents both the remote

gateway and the network behind it across a WAN connection. When you use menu 4 to set up

Internet access, you are configuring one of the remote nodes.

You first choose a remote node in Menu 11- Remote Node Setup. You can then edit that

node's profile in menu 11.1, as well as configure specific settings in three submenus: edit IP

and bridge options in menu 11.3; edit ATM options in menu 11.6; and edit filter sets in menu

This section describes the protocol-independent parameters for a remote node.

To configure a remote node, follow these steps:

1 From the main menu, enter 11 to display Menu 11 - Remote Node Setup.

2 When menu 11 appears, as shown in the following figure, type the number of the remote

node that you want to configure.

Chapter 31 Remote Node Configuration

Prestige 662HW Series User's Guide

This chapter covers remote node configuration.

P-662hw-63 P-662hw-67 Prestige 662hw series