Deleting Certain Parameters From A Scene - Zoom MRS-802 Operation Manual

Reference [Mixer]
H
INT
To cancel a scene assignment, turn the dial to make the
display indicate " -- ".
6.
Locate the next mark at which you want the mix to
change, and repeat steps 4 - 5.
7.
When scenes have been assigned to all marks,
U
press the ZERO [
of the song, and then press the PLAY [
start playback.
Each time the song reaches a mark to which a scene has been
assigned, that scene will be recalled.
Deleting certain parameters from a
scene
If desired, you can disable a group of parameters saved in a
scene. Such parameters will not change even if that scene is
recalled. The following groups of parameters can be
specified and made active or inactive.
Group
TRACK
PARAMETER
INSERT EFFECT
CHORUS/DELAY
REVERB
ALL FADER
For example, after you have programmed a sequence of
automatic scene changes, you may want to disable the
TRACK PARAMETER group and set only the EQ and
panning parameters manually for each track.
1.
Press the [SCENE] key in the control section, and
then press the [UTILITY] key in the display section.
The following screen appears on the display. In this
condition, you can enable or disable the faders for each
scene.
76
] key to return to the beginning
R
] key to
Item
EQ HI
EQ LO
Chorus send
Reverb send
Pan
Play/mute
Patch number
Input source
Patch number
Patch number
Fader position
Permissn Permissn
AllFader AllFader
2.
Turn the dial to set fader permission to ON or OFF.
3.
Press the other keys for parameter groups, to
enable or disable the group.
Except for the fader, scene control for the other groups can
be enabled or disabled by pressing one of the keys listed
below.
• TRACK PARAMETER group
Any status key except [MASTER] status key
• INSERT EFFECT group
Any [INSERT EFFECT] key
• CHORUS/DELAY group
[CHORUS/DELAY] key
• REVERB group
[REVERB] key
When a group is enabled, the respective keys are lit, and
when the group is disabled, the keys are flashing.
H
INT
• The TRACK PARAMETER group can be enabled or
disabled for each audio track and the drum track
separately.
• You can also use the cursor up/down keys to enable or
disable all groups together.
4.
When the setting is complete, press the [EXIT] key.
The unit returns to the scene menu.
5.
To return to the main screen, press the [EXIT] key.
The parameter group on/off status is stored as part of the
project.
ON
ZOOM MRS-802