Table of Contents
Advertisement
Command Center Keys
Your Text command center has nineteen keys for performing the various functions described below:
Key
[1], [2], [3], [4], [5],
[6], [7], [8], [9], [0]
[CMD]
[ALL ON]
[PART ON]
[NO DELAY]
[BYPASS]
[*]
[A], [B], [C]
Command Center Tones
The command center emits several distinct tones and illuminates lights to alert you to system events.
Tone
Description
Fire Alarm
When fire point activates, the command center emits a repeated warble tone (on for 2 sec., then
briefly off).
Burglary Alarm
When a burglary point activates while your system is turned on, the command center emits a
continuous warble tone. The sounder remains on for the duration of the time set by your security
company.
Trouble
When a system component is not functioning properly, your command center emits a repeated
warble tone (on briefly, followed by a pause, followed by the warble tone). Press [4] to view the
trouble. If problem is point-related, the command center display indicates the faulted point.
Key Press
Pressing any key on the command center sounds a short pip to indicate the pressed key is accepted.
Entry Delay
When you enter the premises through a point programmed for Entry Delay, the command center
emits an intermittent beep to remind you to turn your system off. If the system is not turned off
before the Entry Delay expires, an alarm condition occurs and a report may be sent to your alarm
company.
Exit Delay
After you turn your system on, the command center emits an intermittent beep and counts down
the Exit Delay time. If you do not exit before the Exit Delay time expires and an Exit Delay point is
faulted, an alarm event begins.
Error
If you press an incorrect key, your command center emits an error tone to indicate an invalid entry.
The Error Tone is the same warble tone as the Trouble Tone, but is not repeated.
OK
Indicates a command center entry is accepted, such as a correctly entered passcode. The Command
Center emits a single, high-pitched beep for 1 sec.
Watch
If any watched point is faulted, the command center emits a tone to alert. The tone varies in
duration, depending on the selected Watched Tone. (See Select Watch Tone on page 31.)
© 2003 Bosch Security Systems
Function
Numeric keys used to enter passcodes and issue commands.
Used in conjunction with numeric keys to enter commands. Also displays
system status.
Turns your system All On. See Turn the System All On on page 11.
Turns your system Part On. See Turn the System Part On on page 12.
Turns your system All On or Part On without entry or exit delay. See Turn the
System On with No Delay on page 14.
Bypasses one or more points. See Bypass Points on page 18.
When available, advances to the next display.
Emergency functions (Fire, Panic, or Emergency Alarms) may be assigned to
these keys by your security company.
To activate the special function, press the key twice (consecutively) within 2 sec.
Your security company labels each key with its assigned function.
D623/D625 User Guide
Page 7
Security System
User Guide
46841D
Advertisement
Table of Contents
