Table of Contents
Advertisement
How Your System Reports Alarms
Your security system may be programmed to automatically disconnect your telephone when sending reports to your security
company. Once the report is complete, the system returns the telephone to normal operation (check with your security
company).
Your system makes repeated attempts to send reports to your security company. If your system fails to report, the command
center signals a system trouble. See Check System Troubles on page 26 to determine the nature of the trouble.
If your telephone service is interrupted, your security system cannot send reports to your security company unless it
has an alternate means of transmitting them.
IMPORTANT
Check System Status
When the system is Off, press [CMD] to show the current system status. The following message may appear:
System Status Message
System OK
System Trouble!
Press [4] to view
Points faulted
Press [0] to view
Log Out of the System
The system remembers passcodes entered for approximately 10 sec. after you stop pressing keys. To log out of the system,
press the [CMD] key twice. Logged Out appears on the command center display.
Silence Alarms
When an alarm occurs, the alarm tone sounds and the display shows the point(s) in alarm. If you enter your passcode
before the system dials your security company, the alarm report is aborted.
1.
The command center displays the point(s) in alarm.
2.
Enter your passcode to silence the alarm and turn the system off (if it was turned on). An alarm report is sent
to your security company if the alarm is not acknowledged in time.
The display continues to show the point (or points) that caused the alarm.
3.
Press and hold [CMD] to remove the alarm messages from the command center display. See View Alarm
Memory on page 27 to see which points caused the alarm.
© 2003 Bosch Security Systems
Description
Indicates there are no system troubles.
Indicates there is a system trouble. See Check System Troubles on page 26
to determine the nature of the trouble.
Indicates the system has faulted points. See View Faulted Points on page 18
for more information.
Alarm Pt4
Living Room
Enter code to
silence alarm
Silenced alarms
listed below
Alarm Pt8
Motion Detector
To remove
silenced alarms
from display,
hold Cmd
D623/D625 User Guide
Page 9
Security System
User Guide
46841D
Advertisement
Table of Contents
