Table of Contents
Advertisement
Add a Passcode (Cmd 56)
I can perform this command.
I cannot perform this command.
Use this command to add new passcodes to the system. This command requires the appropriate authority level to add
passcodes. To add a new passcode to the system, you must assign an area(s) to the new user in addition to using the other
Cmd 56 features (changing a passcode and changing a passcode authority level) as outlined below. Only use this feature
under the direction of your security company.
1.
Make sure the system is turned off (On indicator is off).
2.
Press [CMD] [5] [6]. The command center may prompt you to enter a valid passcode.
3.
Enter your passcode. The command center scrolls through the following selections:
4.
Press [3] to assign an area(s) to the new user.
5.
Enter the user number you wish to assign area(s) to followed by the [*] key. For example, for User 4, press [4]
[*]). The command center toggles between the following displays:
6.
Enter the area(s) you want to assign to the new user by pressing the appropriate numeric key(s). For example,
if the user is to be assigned to Areas 1 and 2, press the [1] and [2] keys. The command center displays:
To remove a currently assigned area(s), press the corresponding numeric key(s). For example, if User 4 is
assigned to Areas 1 and 2, but should only be assigned to Area 1, press [2] to remove Area 2 from User 4's area
assignment.
7.
Press [CMD] twice to return to the three Cmd 56 selections. Then, press [1] to create a passcode for the new
user.
8.
Enter the user number followed by [*]. For example, press [4] [*] to create the passcode for User 4.
9.
When the display prompts, Please enter new code, enter a new passcode. If the error tone sounds,
try a different new passcode. Enter the new passcode again for verification.
10. Press [CMD] twice to return to the three Cmd 56 selections. Then press [2] to assign a passcode authority level
to the new user.
11. Enter the user number and press [*]. For example, press [4] [*] to assign an authority level for User 4.
12. Enter an authority level (1 to 4) by pressing the appropriate numeric key. command center displays:
The number following the word "level" on the first line indicates the authority level the user passcode is
currently assigned to.
13. Use Steps 1 through 12 to add more new users or press [CMD] until the command center emits a single beep
tone and the display returns to the normal display.
The new user passcode, area assignment and authority level automatically logs into the system's programming
memory. Make sure that your security company's programming records are properly updated.
© 2003 Bosch Security Systems
Push 1 to change
codes.
Push 2 to change
authority level.
Push 3 to change
areas assigned.
Code 4 Areas:
----
Press 1 to 4 to
toggle areas.
Code 4 Areas:
12--
Code 4 level 0.
Enter new level.
D623/D625 User Guide
Page 23
Security System
User Guide
46841D
Advertisement
Table of Contents
