Table of Contents
Advertisement
Procedure
•
Gap dimensions, refer to
⇒ "1.2.2 Hood Gap Dimensions", page 13
•
For the correct tightening specifications, refer to
⇒ "1.2.1 Hood Assembly Overview", page 12
Side and Length Adjustment at Hinge:
– Loosen the left and right nuts -A- on the hinge -2-.
– Adjust hood -1- in the lateral and longitudinal direction.
– Tighten the nuts.
Height Adjustment At Hinge:
– Loosen screws -B- and -C- on the hinge on the left and right.
– Adjust the height of hinge -2- in the area of screw -B-.
– Tighten the bolts.
Note
Check the lid hinge stop bolt height adjustment
Hood Lock Height Adjustment:
•
For the correct tightening specifications; refer to
⇒ "1.2.4 Hood Locks Assembly Overview", page 16
– Loosen the bolts -arrows-.
– Adjust the height of hood lock -1- in front lock carrier -2-.
•
The striker pin with the hood catch must engage vertically in
the hood lock.
– Tighten the bolts.
Height Adjustment at Left and Right Hood Locks:
•
For the correct tightening specifications; refer to
⇒ "1.2.1 Hood Assembly Overview", page 12
– Remove the bolt -1- and the striker pin anti-twist mechanism
-2-.
– Install lid lock striker pin -3- in the hood as far as the stop and
then loosen it 3 turns.
•
During the closing test, the lid must fall from the balance po‐
sition into the lid lock and engage completely.
– Change the striker pin height adjustment if necessary.
– Position the anti-twist mechanism -2- on the striker pin -3-.
– Secure the anti-twist mechanism with the screw.
.
.
⇒ page 39
.
.
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
1. Description and Operation
15
Advertisement
Table of Contents
