Table of Contents
Advertisement
2.2.2
Hood Hinge
Removing
– Remove the hood. Refer to
– Detach gas-filled strut -2- from the lid hinge. Refer to
⇒ "2.2.6 Gas-Filled Strut", page 40
– Detach line channel -1- on the lid hinge by releasing the catch‐
es.
– Mark the installation location of lid hinge -3- with a marker for
reinstallation.
– Remove the bolts -4- and -5-.
Note
Screws -4- and -5- are different lengths.
– Remove the lid hinge.
Installing
•
For the correct tightening specifications, refer to
⇒ "1.2.1 Hood Assembly Overview", page 12
Install in reverse order of removal. Note the following:
– Adjust lid hinge stop screw -1- to dimension -a-.
•
Dimension -a- = 34 mm.
– Install the lid hinge according to the marking applied during
removal.
– Adjust the hood. Refer to
2.2.3
Striker Pin with Catch
Removing
– Remove the cap nuts -3-.
– Remove striker pin -1- with catch on hood -2-.
Installation
•
For the correct tightening specifications; refer to
⇒ "1.2.1 Hood Assembly Overview", page 12
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Install in reverse order of removal.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ "2.2.1 Hood", page 38
.
.
⇒ "1.2.3 Hood, Adjusting", page 14
.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2. Removal and Installation
39
Advertisement
Table of Contents
