Rear Bumper - Audi Tt Rs - Audi TT 207 Repair Manual

Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2.4

Rear Bumper - Audi TT RS

⇒ "2.4.1 Rear Bumper", page 182
⇒ "2.4.2 Rear Bumper Spoiler", page 184
⇒ "2.4.3 Diffuser Trim", page 185
⇒ "2.4.4 Exhaust Pipe Trim", page 185
⇒ "2.4.5 Impact Absorber", page 186
⇒ "2.4.6 Impact Member", page 186
⇒ "2.4.7 Rear Bumper Bracket", page 187
⇒ "2.4.8 Guide Piece", page 187
⇒ "2.4.9 Inner Guide Piece", page 188
2.4.1 Rear Bumper
Removing
– Remove the screws -arrows- from the wheel housing liner and
remove expanding clip -3-.
– To remove the expanding clip, press in clamping pin -1- care‐
fully by dimension -x- until it audibly engages in the expanding
clip -arrow A-.
• Dimension -x- = 5 mm
– Pull out unlocked expanding clip -2- with the clamping pin.
– Bend heat shield -2- back slightly in the area of the screws.
– Remove the bolt -1-.
182
Rep. Gr.63 - Bumpers
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.