Audi TT 207 Repair Manual page 188

Audi TT 2007 ➤
Body Exterior - Edition 11.2010
– Remove the bolt -2-.
– Remove the bumper laterally toward the outside from the body
-arrow A-.
– Disengage the bumper from the clips by releasing retaining
tabs -1-.
– Disengage the bumper on the rear guide piece from the clips
by releasing retaining tabs -3-.
Note
If retaining tabs -3- cannot be released, the strip on the guide
piece must be carefully lifted -arrow B-.
– Thread the electrical wiring harness out of the body opening
and remove the bumper.
Installation
• For the correct tightening specifications, refer to
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
⇒ "1.4.1 Rear Bumper Assembly Overview", page 160
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Install in reverse order of removal. Note the following:
– The bumper must engage completely.
– Install the left and right tail lamp. Refer to ⇒ Electrical Equip‐
ment; Rep. Gr. 94 ; Removal and Installation .
– Install the rear wheel housing liner. Refer to
⇒ "3.8.2 Rear Wheel Housing Liner", page 256
2.4.2 Rear Bumper Spoiler
Removing
– Remove the diffuser trim. Refer to
⇒ "2.4.3 Diffuser Trim", page 185
– Remove screw -4- on the left and right.
– Remove screws -1- and -2- on the lower trim.
– Remove lower trim -3- on the rear bumper -arrows-.
184
Rep. Gr.63 - Bumpers
.
.
.