Removing And Installing Seat Height Adjustment Motor - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
General body repairs, interior - Edition 07.2011
1 - Bolts (2x)
❑ Tightening torque 19
Nm.
2 - Bolts (2x)
❑ Tightening torque 20
Nm.
3 - Mounting plate
4 - Latch
♦ Removing
– Remove the seat
⇒ page 282 .
– Attach the holder for
seat repair -VAS 6136-
to the engine and gear‐
box holder -VAS 6095- .
– Attach the front seat to
the holder for seat repair
-VAS 6136- .
– Unscrew the bolts -1-
(2x).
– Detach the mounting
plate -6- and the latch
-4-.
– For complete removal:
Unscrew the bolts -2-
(2x) and detach the
mounting plate -3-.
♦ Installing
– Following complete re‐
moval: Screw on the
mounting plate -3- with
the bolts -2- (2x).
– Make sure the spring
-7- is inserted in the
mounting plate -6-.
– Insert the latch -4- flush with the stop -5- and the spring -7-.
– Screw on the mounting plate -6- and the latch -4- with the bolts -1- (2x).
5 - Stop
6 - Mounting plate
7 - Spring
1.22 Removing and installing seat height ad‐
justment motor
Special tools and workshop equipment required
302
Rep. gr.72 - Seat frames
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.