Table of Contents
Advertisement
1 - Hydraulic cylinder
❑ Before removal, remove
convertible top.
❑ Removing, refer to
⇒ "1.2.6 Hydraulic Cyl‐
inder Assembly Over‐
view", page 117
2 - Hydraulic line
❑ Unclip hydraulic line to
body -arrows-.
3 - Hydraulic pump housing
❑ To remove, remove
bolts -4- and raise hous‐
ing out of body.
4 - Bolt
❑ 10 Nm
5 - Electric wire
❑ To remove hydraulic
pump, disconnect at
connector.
6 - Body crossmember
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Hydraulic Pump Valve
– Open hydraulic pump valve by rotating valve bolt 180° coun‐
terclockwise using a screwdriver -2- through the opening -3-
in the pump housing cover -1-.
– When closing, tighten hydraulic pump valve bolt to 2 Nm.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
1. Description and Operation
115
Advertisement
Table of Contents
