Spoiler - Tt Rs - Audi TT 207 Repair Manual

Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2.3

Spoiler - TT RS

⇒ "2.3.1 Rear Spoiler Assembly Overview", page 224
2.3.1 Rear Spoiler Assembly Overview
Note
After painting, the spoiler of the TT RS is assembled from the
♦
components shown in the assembly overview.
The spoiler is not designed for disassembly.
♦
1 - Connector housing
❑ Adhered to the spoiler
base plate
❑ For bridging the extend‐
able spoiler connector
2 - Nut
❑ Quantity: 9
❑ 2 Nm
3 - Sealing cord
❑ Replacing
❑ Secure to the spoiler
lower part with instant
adhesive -AMV 195 KD
101-
❑ Process the ends with‐
out a joint
4 - Nut
❑ Quantity: 2
❑ 2 Nm
5 - Spoiler base plate
❑ Removing and Instal‐
ling, refer to
⇒ "3.6.1 Spoiler",
page 240
❑ Assembly, refer to
⇒ "3.6.2 Spoiler, As‐
sembling", page 241
6 - Right cover cap
❑ Secure with double-si‐
ded adhesive tape
7 - Spoiler center part
❑ Assembly, refer to
⇒ "3.6.2 Spoiler, Assembling", page 241
8 - Double-sided adhesive tape
❑ Short, straight
❑ Quantity: 2
9 - Double-sided adhesive tape
❑ Ring-shaped
❑ Quantity: 3
224
Rep. Gr.66 - Exterior Equipment
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.