Removing And Installing Luggage Compartment Aerial For Entry And Start Authorisation R137; Removing And Installing Rear Bumper Aerial For Entry And Start Authorisation R136 - Audi 2003 A8 Workshop Manual

Audi A8 2003 ➤
Electrical system - Edition 08.2014
10.10 Removing and installing luggage com‐
partment aerial for entry and start au‐
thorisation - R137-
Removing
– Remove lower rear shelf trim ⇒ Rep. gr. 70 .
– Unplug electrical connector -3-.
– Remove bolts -1- and -2- and detach luggage compartment
aerial for entry and start authorisation -R137- -item 4-.
Installing
Installation is carried out in the reverse order; note the following:
– Install lower rear shelf trim ⇒ Rep. gr. 70 .
Tightening torque
Component
Luggage compartment aerial for entry and start
authorisation - R137- to body
10.11 Removing and installing rear bumper
aerial for entry and start authorisation -
R136-
Removing
– Remove rear bumper cover ⇒ Rep. gr. 63 .
– Unplug electrical connector -2-.
– Unscrew bolts -arrows-.
– Take rear bumper aerial for entry and start authorisation -
R136- -item 1- out of bumper cover.
Installing
Installation is carried out in the reverse order; note the following:
– Install rear bumper cover ⇒ Rep. gr. 63 .
Vehicles with lane change assist:
Lane change assist control unit -J769- / -J770- must be recali‐
brated whenever bumper cover has been removed
⇒ "12.5 Calibrating lane change assist - test equipment layout",
page 321 .
Tightening torque
Component
Rear bumper aerial for entry and start authori‐
sation - R136- to rear bumper cover
314
Rep. gr.96 - Lights, bulbs, switches - interior
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
Nm
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.4
Nm
2.5