Auxiliary Hydraulic Pump Control Module J922 , Removing And Installing - Audi Q7 2007 Repair Manual

1.3 Auxiliary Hydraulic Pump Control Mod‐
ule - J922- , Removing and Installing
Removing
– Turn off the ignition and remove the key.
– Remove the front passenger seat. Refer to ⇒ Body Interior;
Rep. Gr. 72 .
– Release the tabs and open the cover on the Auxiliary Hydraulic
Pump Control Module - J922- housing.
– Release the tabs in the direction of -arrows-, remove the Aux‐
iliary Hydraulic Pump Control Module - J922- and disconnect
the connector.
Installing
Install in reverse order of removal. Note the following:
– Install the front passenger seat. Refer to ⇒ Body Interior; Rep.
Gr. 72 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
8-Speed Automatic Transmission 0C8 - Edition 08.2017
1. Electrical and Electronic Components and Component Locations
Audi Q7 2007 ➤
25