Router; Enter Configuration Mode; Configure User Accounts And Passwords - Juniper TX Matrix Plus Quick Start Manual

TX Matrix Plus Router Quick Start
Step 10: Perform the Initial Software Configuration for the TX Matrix Plus Router

Enter Configuration Mode

Configure User Accounts and Passwords

30
These procedures connect a TX Matrix Plus router to the network but do not enable it to
forward traffic. For complete information about enabling the router to forward traffic,
including examples, see the Junos OS configuration guides.
For the initial configuration of the TX Matrix Plus router, issue Junos OS command-line
interface (CLI) commands from a console device attached to the
TXP-CB.
NOTE: These procedures enable you to use the management Ethernet port.
Enter Configuration Mode on page 30
1.
Configure User Accounts and Passwords on page 30
2.
Configure System Attributes on page 31
3.
4. Commit the Configuration on page 32
Verify that the network device is powered on.
1.
Log in as the root user. There is no password.
2.
Amnesiac <ttyd0>
login: root
Start the CLI.
3.
root@% cli
root>
Enter configuration mode.
4.
root> configure
Entering configuration mode.
[edit]
root#
For information about using an encrypted password or an SSH public key string (DSA or
RSA), see authentication.
Add a password to the root administration user account. Enter a clear-text password.
1.
[edit]
root# set system root-authentication plain-text-password
New password: password
Retype new password: password
Create a management console user account.
2.
[edit]
CONSOLE port on the
Copyright © 2015, Juniper Networks, Inc.