Juniper TX Matrix Plus Quick Start Manual page 13

Copyright © 2015, Juniper Networks, Inc.
NOTE: For detailed instructions on removing TX Matrix Plus router
components, see the TX Matrix Plus Router Hardware Guide.
To remove the components from the TX Matrix Plus router:
Slide each component out of the chassis evenly so that it does not become stuck or
1.
damaged.
Label each component as you remove it so you can reinstall it in the correct location.
2.
Immediately store each removed component in an electrostatic bag.
3.
Do not stack removed components. Lay each one on a flat surface.
4.
Figure 5: Rear of the TX Matrix Plus Router
Air exhaust
TXP-F13 SIBs
Air exhaust
Fan tray 2
Air exhaust
Fan tray 3
PEM 0
PEM 1
Remove TX Matrix Plus Components
ESD point
Fan tray 4
Fan tray 5
Grounding points
ESD point
13