Juniper TX Matrix Plus Quick Start Manual page 17

Copyright © 2015, Juniper Networks, Inc.
To install the TX Matrix Plus router using a lift (see
Load the TX Matrix Plus router onto the lift, making sure the router rests securely on
1.
the mechanical lift.
CAUTION: Do not lift the TX Matrix Plus router using the handles on the
sides of the chassis. Use these handles only to help position the TX Matrix
Plus router.
Using the lift, position the TX Matrix Plus router in front of the rack, centering it in front
2.
of the mounting shelf.
Lift the chassis slightly above the surface of the mounting shelf, and position it as
3.
close as possible to the shelf.
Carefully slide the TX Matrix Plus router onto the mounting shelf, so that the bottom
4.
of the chassis and the mounting shelf overlap by approximately 2 inches.
With four people pushing on the front-mounting flanges, slide the TX Matrix Plus
5.
router onto the mounting shelf until the center-mounting brackets (open-frame racks)
or front-mounting flanges (four-post racks) contact the rack rails. The shelves ensure
that the holes in the center-mounting brackets and the front-mounting flanges of the
chassis align with the holes in the rack rails.
Move the lift away from the rack.
6.
Install a mounting screw into each of the mounting holes aligned with the rack, starting
7.
from the bottom.
Visually inspect the alignment of the TX Matrix Plus router. If the router is installed
8.
properly in the rack, all the mounting screws on one side of the rack should be aligned
with the mounting screws on the opposite side, and the router should be level.
Install the TX Matrix Plus Router Using a Lift
Figure 7 on page 16):
17