Changing Height Adjustment Cable - Husqvarna P524 Workshop Manual

5.7.8 Changing height adjustment cable

Tools
Combination wrench x2
Combination wrench x2
Torx
Dismantling
1. Remove the cutting deck. For further
instructions, refer to section "5.7.2 Cutting
deck" on page 78.
2. Release the lifting chain from the tool frame.
3. Dismantle the protecting cover on the tool
frame.
4. Remove the pulley and the cable retainer.
5. Loosen the locknuts on the cable sheath.
6. Pull back the rubber protection so that the cable
can pass through the bracket opening.
7. Take the cable out of the rubber strap.
Dimension
13 mm
17 mm
T30
8. Remove the right side cover.
9. Loosen the front snap lock on the cable.
10. Pull back the rubber protection so that the
cable can pass through the bracket opening.
Loosen the locknut and take the cable out
through the bracket.
Cutting system
English – 83