Husqvarna P524 Workshop Manual page 61

Hydraulic system
Dismantling
1. Raise the machine and support it under the
frame. Refer to the illustration for the permitted
area.
2. Dismantle the rear wheels and aluminum hubs
from the transmission. Refer to "5.1.4 Wheel
hub" on page 21.
3. Dismantle the cover over the rear transmission.
4. Place a vessel under the transmission to collect
oil spill.
5. Clean according to the general instructions.
6. The hydraulic hoses can be mixed up. Mark the
lines so that they are reconnected on the correct
connections.
7. Loosen the hydraulic lines (1), (2) and (3). Fit
sealing plugs to prevent leakage and
contamination.
1
1. Hydraulic line
2. Hydraulic line
60 – English
2
3
3. Hydraulic line
8. Loosen the rear end of the control stay (1) by
dismantling the screw (3) with nut (5). Make
sure not to misplace the bushing (4).
9. Loosen the front end of the control stay by
dismantling the screw (6) with nut (7).
10. Remove the control stay.
6
7
8
1. Control stay
2. Linkage
3. Screw
4. Bushing
WARNING!
Heavy objects are released when
dismantling the transmission.
11. Remove the screws in the bearing units, two on
each wheel.
12. Remove the stop screws.
2
1
5
4 3
5. Nuts
6. Screw
7. Nut
8. Washer