Changing Parking Brake Cable - Husqvarna P 520D Workshop Manual

Changing Parking Brake Cable

Tools Dimension
Combination 13 mm
wrench
Torx
Snipe nose pliers
Torque wrench
U-grip for torque 13 mm
wrench
Remove the seat if fitted for better access. See
Removing Driver's Seat.
1. Release the parking brake.
1 2 3
1. Parking brake cable
2. Spring
2. Loosen the lock nut (2) on the transmission end
of the cable.
3. Remove the split pin (4) and clevis pin (5), and
pull the torsion spring (6) away from the arm (1).
1
4
5
6
1. Arm
2. Lock nut
3. Parking brake cable
Quantity
1
T 30 1
1
1
1
4
3. Bracket
4. Transmission bracket
2
3
4. Split pin
5. Clevis pin
6. Tension spring
4. Dismantle two screws (1) for the parking brake
bracket (2). Carefully bend the bracket out from
the overlying frame section to expose the cable
fastening.
5. Remove the cable eye (4) from the spring (5).
6. Refit the new cable in reverse order.
7. Check the handbrake adjustment in accordance
with the operator's manual.
8. Torque tighten the nut/lock nut to 20 Nm.
1. Screw
2. Bracket
3. Cable
Chassis
1
5 4 3
4. Eyelet
5. Spring
English –
2
9