Cooling System; Changing The Oil Cooler - Husqvarna P524 Workshop Manual

Cooling system

5.5 Cooling system

5.5.1 Changing the oil cooler

Dismantling
Tools
Combination wrench
Combination wrench
1. Open the engine cover.
2. Loosen the electrical connector.
3. Mark the hydraulic hoses so that they are
reconnected correctly.
4. Clean thoroughly as instructed. For further
instructions, refer to section "5.6.1 Hydraulic
hygiene" on page 52.
5. Loosen the hydraulic hoses. Fit sealing plugs to
prevent leakage and contamination.
50 – English
Dimension
10 mm
19 mm
6. Remove the screws, two on each side of the
cooler.
7. Lift away the oil cooler.
Assembling
Assemble in reverse order.