Dismantling the throttle and choke
cables
1. Remove the side cover.
2. Loosen the circuit board by removing the nut.
Move the circuit board out of the way.
3. Remove the knobs from the throttle and choke
controls.
4. Loosen the control console by removing the
screws.
5. Pull the throttle or choke control down through
the opening.
6.
Cut the front tie bands.
7. Loosen the wire from the control.
8. Cut the rear tie bands.
9. Loosen the throttle cable from the fastening
hole in the lower lever arm or loosen the choke
cable from the fastening hole in the upper lever
arm.
Assembling
1.
Assemble in reverse order.
2.
Must be adjusted and checked after fitting.
Chassis
English – 17