Husqvarna P524 Workshop Manual page 66

6. Undo the hydraulic pipe and hoses from the front
axle.
7. Remove the parking brake cable. For more
information, refer to "5.1.3 Brake cable" on
page 19.
8. Loosen the screws holding the bearing unit and
remove the bearing on the right/left side.
9. Remove the screws holding the front axle and
lower the front axle.
Assembling
Reassemble the front axle in reverse order in
relation to removal. The bearing on the left side is
turned so the grease nipple points backwards.
1. First assemble all the screws on the front axle
and the bearings loosely in order to guide the
axles into the best position. Then tighten the
three M12 screws in the front axle and then the
wheel bearings. Make sure the axles are rotating
freely.
2. The stop screws for the right side bearing are
tightened after the four screws holding the wheel
bearings have been tightened.
3. Grease the axles with corrosion protection
before fitting the wheels.
4. Fill the hydraulic system with oil.
5. Check and adjust the parking brake cable.
6. Check and adjust speed coordination between
the front wheels and rear wheels as described in
"5.2.10 Wheel speed" on page 39.
Hydraulic system
English – 65