Setting Parallelism And Cutting Height; Adjusting The Parallelism Of The Cutting Deck - Husqvarna P524 Workshop Manual

5.7.4 Setting parallelism and cutting
height
Parallelism and cutting height must be adjusted
when a new cutting deck is fitted.
Starting point:
• Check tire pressure, see section
"6 Specifications" on page 85.
• The cutting deck must be lowered on a level
surface.
• The height adjustment lever shall be set to the
lowest cutting height, position 1.
5.7.5 Adjusting the parallelism of the
cutting deck
1. Remove the front cover.
2. Loosen the nuts on the parallel strut.
3. Screw out (extend) the strut to raise the rear edge
of the cover. Screw in (shorten) the strut to lower
the rear edge of the cover.
4. Tighten the nuts after adjustment.
5. The parallelism of the cutting deck should be
checked again after the adjustment has been
made.
6. Fit the front cover.
7. Measure the cutting deck at the front and the
back. The measurement at the back should
always be 4 mm higher than the front.
NB!
A new parallelism and cutting height
adjustment must be made when changing
cutting deck.
Cutting system
English – 81