Power Steering - Husqvarna P524 Workshop Manual

5.6.14 Power steering

Tools
Torx
Combination wrench
Combination wrench
Combination wrench
Combination wrench
Dismantling
1. Remove the front cover, steering column.
2. Unscrew the two screws holding the lamp insert.
Lift out the lamp insert.
3. Disconnect the cables from the bulbs.
5
6
4
3
1
2
1. Power steering
2. Cover
3. Key
4. Steering wheel
Dimension
T30
13 mm
13 mm
14 mm
19 mm
7
5. Steering wheel hub
6. Screw
7. Washer
4. Dismantle the steering wheel (4), secured using
one screw (6) under the steering wheel hub (5).
Retain the key (5) and the washer (7). Dismantle
the cover (2) over the steering servo housing.
IMPORTANT!
Do not use force, use a puller if the steering
wheel is stuck hard.
5. Unscrew the four screws holding the cover (2) in
front of the steering servo housing.
6. Place a container under the steering servo to
collect the spill oil.
7. Clean according to the general instructions, see
"5.6.1 Hydraulic hygiene" on page 52. Mark up
how the hydraulic lines are situated on the
power steering.
8. Loosen the hydraulic lines from the steering
servo (1). Fit protective plugs.
E
R
L
Assembling
1. Assemble the power steering servo in the
reverse order.
2. Place the power steering servo so the small
connection is pointing backwards.
3. Tightening torque for screws and hydraulic lines
as set out in the "6 Specifications" on page 85.
4. Do not forget the key when assembling the
steering wheel.
5. Start the engine and turn to full lock. Check for
leakage.
6. Top up the hydraulic oil if necessary.
Hydraulic system
T
P
English – 75