Table of Contents
Advertisement
WORKSHOP MANUAL
TC 108 SD - TC 118 SD
General informations
This operation should be carried out every time
the rear axle, pedal or control rod is removed, in
order to get the correct travel for the pedal and to
reach the envisaged speeds both forwards and
in reverse.
Related topics
[
7.10]
Fitting safety microswitches
Map of functional units
DRIVE PEDAL ADJUSTMENT
A) Adjusting the pedal in the "neutral" position
Adjustment of the pedal position must be carried out
with the hydraulic unit lever in the "neutral" position
(1); this position «N» can be easily recognised as it is
forced to stay there by a fastening sphere.
Open the inspection hatch which is placed at the base
of the seat; the drive control pedal is in its ideal po-
sition when the lever (1) of the hydrostatic unit is in
"neutral", and the internal lever (2) on the pedal axle is
perfectly vertical.
This is obtained using a bracket (3), by working on
N
1
8
6
4
4
3
2
CHAPTER
REVISION
4.4
the nuts (4) until reaching the desired situation. Taking
care not to accidently change the position of the lever
(1) during the adjustment.
B) Adjusting the "neutral" position of the
IMPORTANT This is a very important adjust
ment for the correct operation of the safety devices
for starting and stopping of the machine during work.
The neutral position «N» is signalled by the micro-
switch (5) of the cam (6), accessible from the inspec-
tion hatch which is placed at the base of the seat.
After checking that the adjustment "A" has been cor-
rectly made, make sure that the pedal is released and
in neutral "N" then loosen the screws (7) that fasten
the microswitch support (8), until the roller is in line
with the tip of the cam, so that the microswitch re-
mains activated.
By moving the pedal to the forward gear and neutral
position, you should hear the click of the button at
each gear change before the wheels start moving.
7
FROM ...
PAGE
0
2018
1 of 1
micro switch
5
6
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
