Stiga TC 108 SD Workshop Manual page 34

WORKSHOP MANUAL
REMOVING, SHARPENING AND BA LANCING
CHAPTER REVISION FROM ... PAGE
TC 108 SD - TC 118 SD 4.9 0 2018 2 of 2
THE BLADES
B) Sharpening and balancing
Always sharpen both cutting edges of the blade (2)
u sing a medium grade grinder. Sharpening must on-
ly be done from the rounded side, removing as lit tle
material as possible.
The blade is to be replaced when the cutting edge has
worn down to 10 mm.
160 mm
2
2
Using the appropriate equipment, check the ba lance
to make sure that there is a maximum diffe rence of 2
grams between one side and the other.
2