Replacement Of Tyres And Wheels - Stiga TC 108 SD Workshop Manual

WORKSHOP MANUAL
TC 108 SD - TC 118 SD
General informations
The tyres used are of the "Tubeless" type and so
e ve ry repair of a hole in the tyre must be done by
a ty re specialist according to the methods used
for this type of tyre.
Related topics
[ 2.3] Lifting of the machine
[ 4.5] Aligning the cutting deck (
[ 4.5a] Aligning the cutting deck (
Tyre pressures
Front ......................................................... 1,0 Bar
Rear .......................................................... 1,4 Bar
Map of functional units

REPLACEMENT OF TYRES AND WHEELS

After replacing one or more tyres or the wheels, it is
al ways necessary to check the pressure and to check
the alignment of the cutting deck.
ATTENZIONE
as they could impair the tyre's hold.
TC 108 SD)
TC 118 SD)
The wheels are held by a snap ring (1) which can be
removed with the help of a screwdriver.
1
NOTE If a wheel is jammed onto the shaft, use a
releasing spray, directing it around the splining hole.
A) Tyres
Replace distorted wheel rims
B) Wheels
CHAPTER REVISION FROM ...
6.1 0 2018
On assembly it is advisable to spread grease on the
shaft to facilitate the next wheel removal.
● For the front wheels: replace the shoulder washer
(2) and the flexible ring (1) with the bevel facing in-
wards.
● For the rear wheels: replace the shoulder washer
(2) and the flexible ring (1) with the bevel facing in-
wards and check the axial gap of the wheel on the
shaft; if it is greater than 3 mm, a spacer (3) must be
fitted between the wheel hub and the shoulder wa-
sher (2).
PAGE
1 of 1
3
2
1