Identification - Stiga TC 108 SD Workshop Manual

WORKSHOP MANUAL
TC 108 SD - TC 118 SD
General informations
This chapter covers all the main aspects of the
re la tionship between the Manufacturer and the
Ser vice Centres.
A close collaboration between the Manufacturer
and the Service Centres is conclusive for solv­
ing pro blems in the most effective way as well as
main taining an image of efficiency and reliability.
Compliance with these brief and simple guide­
lines will facilitate this task and prevent general
misunderstandings and time­wasting for both the
manufacturer and the service centre.
Related topics
---
Map of functional units
IDENTIFICATION AND PROCEDURES
A) Identification
1) Machine
Each machine has a label attached (1) under the dri-
ver's seat which shows the technical specifications,
the model and the serial number..
The model and serial number must be shown on
each repair sheet when requests are made un der
guarantee, and are indispensable for spare part
orders.
2) Transmission
The transmission hydrostatic unit is made up of an en-
gine block including the rear axle. This unit is made by
another manufactu rer to our precise technical specifi-
cations which diffe rentiate it from similar items by this
same Manufacturer.
The serial number on the label (2) clearly iden-
tifies the product and its specifications. This
CHAPTER
1.1
number must always be quoted when requesting
spare parts or any information from the Manufac-
turer.
3) Engine
The engine is made to precise technical specifica-
tions which differentiate it from similar items by this
same Manufacturer.
1
The serial number on the label clearly identifies
the product and its specifications. This number
must always be quoted when requesting spare
parts or any information from the Manufacturer.
The guarantee is supplied under the terms and the
limits of the contractual relations in being. As far as
the engine and the transmission unit are concerned,
the conditions given by their respective manufactur-
ers apply.
REVISION FROM ... PAGE
0 2018 1 of 2
2
B) Guarantee validity