Removal Of The Wheel Cover; Removing The Rear Of The Wheel Cover Only; Removing The Whole Wheel Cover - Stiga TC 108 SD Workshop Manual

WORKSHOP MANUAL
TC 108 SD - TC 118 SD
General informations
Removing the wheel cover gives access to:
– the mount for the lever to raise the deck;
– the supports of the footboards.
Removing the rear section of the wheel cover
makes it possible to access the rear tank and
necessary in order to access the transmission
belt..
Related topics
---
Tightening torques
20 Lower cover fixing screw .............4,0 ÷ 4,5 Nm
Map of functional units

REMOVAL OF THE WHEEL COVER

A) Removing the rear of the wheel cover only
2
Loosen the two screws (1) and disassemble the two
side sections (2), unhooking the 7 fastener tabs (3)
positioned inside each of them.
Remove the rear cover (4) fixed with four screws (5).
3 3
2
CHAPTER REVISION
5.2
B) Removing the whole wheel cover
1
● Remove the rear cover as shown in point A).
FIRST disconnect the black cables (mass) and ONLY
THEN the red cable (positive) on the battery (11).
Disassemble the spring (12) and remove the battery
(11).
Remove the caps (13), loosen the internal screws (14)
and remove the springs (15).
Disassemble the two pins (16) and remove the seat.
3
3
3
16
3
3
FROM ... PAGE
1 2018 1 of 2
4
5
5
16
11 12
13
14
15