Stiga TC 108 SD Workshop Manual page 39

WORKSHOP MANUAL
TC 108 SD - TC 118 SD
Disconnect the accelerator cable terminal from the
engine and disconnect all remaining electrical con-
nections and the starter cable (where present).
The dashboard (13) can be removed at this point; it is
fix ed to the chassis by two upper screws (14), co vered
by plastic caps, and three lower screws (15).
14
13
15
On assembly, follow the steps described in reverse,
being careful to restore wheel alignment with the
steering wheel, install the Belleville washer (3) with
the concave part facing down and fully tighten the
screw (2).
2
3
1 4
REMOVING THE DASHBOARD
AND FRONT COVER
B) Removing the front cover
Remove the dashboard [see point "A"].
Remove the parking brake lever knob (21) or (22) and
dismantle the front guard (23) fixed to the chassis by
six screws (24).
22
15
13
24
1a
1a
21
24
23
24
CHAPTER REVISION FROM ...
5.3 0 2018
PAGE
2 of 2