Dismantling Of The Steering Components; Dismantling The Steering Pinion And Ring Gear - Stiga TC 108 SD Workshop Manual

WORKSHOP MANUAL
TC 108 SD - TC 118 SD
General informations
­­­
Related topics
[ 4,7] Steering geometry adjustment
Tightening torques
4 Nut for Ring gear .............................45 ÷ 50 Nm
11 Nuts for toothed sector fastening ..10 ÷ 15 Nm
13 Nuts for bearing fastening .............25 ÷ 30 Nm
Map of functional units
DISMANTLING OF THE STEERING
COMPONENTS
Release the spring (1).
Loosen the grub screw (3a) and lift the steering col-
umn (2) just enough to be able to extract the pinion
(3).
1
A) Dismantling the steering pinion and ring gear
Remove the tie-rod (6), unscrew the nut (4) and take
out the whole ring gear shaft (5) being careful not to
lose the washers (7) and (8) under the screw head (9).
2
3a
3
CHAPTER
6.3
Toothed sectors (10) are secured to the ring gear (5)
by screws and nuts (11).
4
11
When replacing, be careful to assemble sectors with
the flared part of the teeth facing down.
Check ring gear allowance (5) compared to the pin
(12); if excessive, replace the bearing.
Unscrew the three nuts (13), remove the support (14)
and slide out the bearing (15) to replace.
4
3a
3
10
11
5
6
REVISION FROM ...
0 2018
10 14
12
2
15
5
13 16
1
8 7 9
PAGE
1 of 2
5
4 14
12
17