Stiga TC 108 SD Workshop Manual page 60

WORKSHOP MANUAL
TC 108 SD - TC 118 SD
25
28
27
After having removed the key (25), the snap ring (26)
and the dust cover (27), the bearing (28) splined onto
the shaft can be removed using a normal ex trac tor,
being careful to close the threaded hole (29) with a
suitable screw to prevent the tip of the ex trac tor from
damaging the thread.
The second bearing still in place must be removed by
hitting it from the inside of the flange using a
12 ÷ 15 mm diameter round bar (30).
30
21
REPLACEMENT OF THE SUPPORTS
AND SHAFTS OF THE BLADES
On reassembly, having first inserted the shaft in the lo-
wer bearing hole and inserted everything into the sup-
port, fit the upper bearing using the specific stopper
(31) that acts on the inner ring, hitting it squarely with
29
a mallet until the bearing is fully driven home.
26
Refit the flanged supports onto the deck, fully tighte-
ning the nuts (22).
IMPORTANT When refitting the plate (10), the holes
correspon ding to the support axes must meet
perfectly in the centring step (32) cut into the up­
per part of each support.
Reassemble the blades.
Reassemble the blade control belt.
31
32
21
CHAPTER REVISION FROM ...
6.6 0 2018
PAGE
2 of 2