Cutting Height Adjustment - Stiga G 300 Instruction Manual

5.6.

CUTTING HEIGHT ADJUSTMENT

The "CUTTING HEIGHT ADJUSTMENT" procedure describes how to adjust the height of the cutting
blades.
• The length X of grass cut by the robot lawn mower must not exceed 10 mm.
• The robot lawn mower's operating range is 20-60 mm (cutting height).
• The initial height of the grass Y must therefore be 70mm maximum.
At the first installation or at the beginning of the mowing season, if necessary, prepare the garden with a
traditional lawn mower to bring the initial height of the grass to an appropriate value.
NOTE: If you want to cut the grass more than 10mm, adjust the cutting height so that the cut grass part
is 10mm. Lower the cutting height further only after the garden has been mowed evenly.
Procedure (TYPE: SRSW01 - MODEL G 300, G 600, G 1200). MANUAL ADJUSTMENT:
1. Press the "STOP" button (A) to open the cover (B) and access the control panel (C).
2. Switch off the robot lawn mower in safety conditions (see Par. 2.3).
3. Use the height adjuster (P) to select the desired cutting height so that the cut grass part is no more
than 1 cm.
4. Insert the safety key (D).
NOTE: On the knob there is a scale graduated from 1 to 10 (Q) to be used as a reference.
A C
EN
X
D
B
Y
P Q
5. OPERATION
47