• aso
SET (OSO settings)
Use to adjust the display position and to set the display
time of the OSD.
B)OSD SET
.. OSD SHIFT·········· 0
OSD DISPLRV TU1E··
·O~l
[JL)/[T): Up/Dol,Jn
[-tI)/[~):
Sel
[EtHER):Return
OSD SHIFT (OSD shift)
Use to adjust the vertical position of the OSD. Adjust
toward the - (minus) direction to raise the position of the
OSD, and adjust toward the + (plus) direction to lower it.
Choices: -5 to +5
Initial setting: 0
OSD DISPLAY TIME (OSD display time)
(U.S.A., Canada, and Australia models only)
Use to set the interval for which the OSD screen is
displayed after an operation.
Choices: ON, lOs, 30s
• Select ON to show the OSD screen constantly.
• Select lOs to turn off the OSD screen 10 seconds after
an operation.
• Select 30s to turn off the OSD screen 30 seconds after
an operation.
;-'4<-:
The OSD display time setting is available for your iPod and XM
Satellite Radio (U.S.A. and Canada models only). For details, see
pages 4 and 10 in the Reference Guide.
•
UNIT SET (Unit settings)
Use this to change the display unit of measurement.
Choices: METERS (Australia, Europe, Asia, and Korea
models), FEET (U.S.A. and Canada models)
,.,', II:
l'!'~
,-r-~
i • .
}!JrH
I
:t
I
~METERS
FEET
[-tI)/[
~]:
Se lect
[E~nER]:
Return
• Select METERS to enter distances in meters.
• Select FEET to enter distances in feet.
Notei
If you change this setting, the adjusted sound beam settings may
change.
MANUAL SETUP
89
En
•