Error Messages For Auto Setup - Yamaha YSP-4000 Owner's Manual

AUTO SETUP (InteIliBeam)
• Error messages for AUTO SETUP
Before the AUTO SETUP procedure starts
Error message
Cause Remedy
See
page
ERROR E-2
The IntelliBeam microphone is not Connect the IntelliBeam microphone to 38
No MIC detected. Please check connected to this unit. this unit.
MIC connection and re-try.
While the AUTO SETUP procedure is in progress
If one of the errors listed below except E-l is displayed, press RETURN. In case you have started the AUTO SETUP
procedure by pressing AUTO SETUP in step 3, run the procedure again from step 3 after the screen disappears. In case
you have started the AUTO SETUP procedure by pressing MENU in step 3, run the procedure again from step 4 after the
screen in step 3 is displayed. Run MANUAL SETUP if the problem is difficult to be saved.
Error message Cause
Remedy
See
page
ERROR E-1 There is too much unwanted noise in Make sure that your listening room is as -
Please test in quieter environment. your listening room. quiet as possible. You may want to
choose certain hours during the day
when there is not much noise coming
from outside.
ERROR E-2 The IntelliBeam microphone was Make sure that the IntelliBeam
38
No MIC detected. Please check disconnected while the AUTO SETUP microphone is firmly connected to this
MIC connection and re-try. procedure was in progress. unit.
ERROR E·3
Some other operations were performed Do not perform any other operations -
Unexpected control is detected. on this unit while the AUTO SETUP while the AUTO SETUP procedure is in
Please re-try. procedure was in progress. progress.
ERROR E-4 The IntelliBeam microphone is not Make sure that the IntelliBeam 38
Please check MIC position. MIC placed in front of this unit. microphone is installed in front of this
should be set in front of YSP. unit.
ERROR E·5 The IntelliBeam microphone is not Make sure that the IntelliBeam 38
Please check MIC position. MIC placed in the right distance from this microphone is installed more than
1.8
m
should be set above 1.8m/6.0ft. unit. (6.0
ft)
from the front of this unit and
within I m (3.3
ft)
from the center height
of this unit.
ERROR E·6 The IntelliBeam microphone cannot
Make sure that the IntelliBeam
38
Volume level is lower than collect the sound produced by this unit microphone is firmly connected to this
expected. Please check MIC because the sound output level is too low. unit and placed in a proper location. If
position/connection and re-try. the problem persists, contact the nearest
authorized Yamaha service center for
assistance.
ERROR E·7 An internal system error occurred. Repeat the AUTO SETUP procedure.
-
Unexpected error happened.
Please re-try.
43
En
•