Carry Out The Auto Setup (Intellibeam) - Yamaha YSP-4000 Owner's Manual

Continued from the front
v '
Carry out the AUTO SETUP'
(Int~lliBeam)
, ,
Carry out the AUTO SETUP to adjust the settings that best match your
listening environment
The IntelliBeam technology allows you to achieve sound adjustments that best match your listening environment. It
IS
normal for loud test tones to be output
during the AUTO SETUP procedure. Make sure that there are no children around in the listening room while the AUTO SETUP procedure is in progress.
o
Connect the supplied IntelliBeam microphone to the INTELLIBEAM MIC
jack on the front panel.
You may want to use the supplied cardboard microphone stand for the AUTO SETUP. Assemble the stand and place the IntelliBeam
microphone on top of it as shown below.
IntelliBeam microphone (supplied)
Cardboard microphone stand (supplied)
2
• Set the IntelliBeam microphone at your normal listening position.
Use the supplied cardboard microphone stand or a tripod to place the IntelliBeam microphone at the same height as your ears would
be when you are seated.
IntelliBeam Upper bound
microphone position of the
microphone
cen~~fsh~~~tt
of /
& - - - -
1
Within 1 m
_ _ i3:3
tt)
ithin 1 m
( .3 tt)
, . ----=----
Listening
: microphone stand: position
: - More than 1.8 m (6.0 tt) --:Lower bound position
of the microphone
Center line:
Cardboard
microphone
stand
IntelliBeam
microphone
Place the IntelliBeam microphone on
the extended center line of this unit
and 1.8 m (6.0 tt) or more away from
it. Also, make sure place the
IntelliBeam microphone within 1 m
(3.3 tt) upper or lower from the center
height of this unit.
• Press STANDBY/ON on the
remote control.
The power of this unit turns on.
Before operations, insert batteries into the remote control
(see page 32 in the Owner's Manual).
If necessary, adjust the volume level of this unit.
If you have connected the subwoofer, set the volume and
crossover/high cut frequency. Refer to the note on page
38 in the Owner's Manual.
Subwoofer
VOLUME
CROSSOVER!
POWER POWER
~ HIGH CUT
•
-~-
(3 8 §3 t3
MIN MAX
MIN MAX/
'"
~
• Turn on the power of your TV.
• Select the appropriate video
input on your TV.
If the OSD video pin cable is connected to the video input 1
on the TV as shown in the connection example, switch the
video input to "1".