Setting the SCSI ID of the Internal MO Drive
Setting the SCSI ID of the internal MO disk drive involves removing the D24's top cover
and setting the DIP switch located on the MO drive's circuit board.
This procedure should be carried out by a qualified engineer. If in doubt, contact your
Yamaha dealer.
Remove the top-cover fixing
1
screws (11), as shown here.
Remove the top cover.
2
Using a small flat-bladed screw-
3
driver, or something similar, set
DIP switches 1 through 3, as
listed below, to achieve the
required SCSI ID.
SCSI ID
5
4
3
2 (default)
1
0
SCSI IDs 6 and 7 are not listed, since they are reserved for other purposes.
Setting the SCSI ID of the Internal MO Drive
DIP switch number
1
2
ON
OFF
ON
OFF
OFF
ON
OFF
ON
OFF
OFF
OFF
OFF
193
Appendix
3
ON
OFF
ON
OFF
ON
OFF
D24—Owner's Manual