Yamaha D24 Owner's Manual page 178

Supported MMC Commands
The D24 supports the following MMC commands.
Command
Stop
Play
Play
Fast Forward
Rewind
Record Strobe
Record Exit
MMC Reset
Eject
Write
Locate
REC Mode
Track Record Ready
Setting the MMC Device Number
When MMC is used with several MIDI devices, each must be assigned an exclusive
identity number, so that only the intended device responds to the transmitted com-
mands.
Press the [UTILITY] button.
1
The UTILITY indicator lights up.
Use the JOG/DATA dial to select "MMC DEVICE," and then press the [ENTER]
2
button.
The current MMC Device setting appears on the display.
Use the JOG/DATA dial to select a device number from 1 through 127.
3
The default setting is 1.
Press the [ENTER] button to activate your selection, or the [CANCEL] button
4
to cancel the MMC Device function.
Press the [UTILITY] button again to leave utility.
5
The UTILITY indicator goes out.
Using MMC (MIDI Machine Control)
MMC #
The D24 stops recording, rehearsal, playback,
01
rewind, or fast forward.
The D24 starts playback. This command is
02
ignored during recording or rehearsal.
The D24 locates to the specified timecode
03 address, and then starts playback. This com-
mand is ignored during recording or rehearsal.
The D24 fast forwards. If this command is
received during recording or rehearsal, the
04
D24 stops recording or rehearsal and fast for-
wards.
The D24 rewinds. If this command is received
05 during recording or rehearsal, the D24 stops
recording or rehearsal and rewinds.
If the D24 is stopped, it starts recording. If it's
06
playing, it punches in.
07 The D24 stops recording.
The D24 resets its MMC functions to their ini-
0D
tial values.
OA Ejects the disk.
The D24 writes the data to the specified infor-
40
mation field.
The D24 locates to the timecode address
44
stored in the specified information field.
Toggles the D24 between Rehearsal and
Information field 4C
Record.
Information field 4F Selects tracks for recording.
179
Description
D24—Owner's Manual