Auto Punch In/Out Rehearsal - Yamaha D24 Owner's Manual

72
Chapter 7—Punch In/Out Recording

Auto Punch In/Out Rehearsal

The Rehearse function allows you to practice auto punch-in/out recording without
actually recording anything to disk. With the Auto Input monitoring function turned
on, playback and input monitor switching is performed automatically at the LAST REC
IN and OUT points. See "Monitoring" on page 42 for more information.
The following illustration shows the procedure for auto punch-in/out rehearsal.
READY
2
RECORD
READY
Set the LAST REC IN and OUT points. See "Setting the LAST REC IN & OUT
1
Points" on page 71 for more information.
Use the [RECORD READY] buttons to select tracks for recording.
2
The corresponding READY indicators flash.
Press the [AUTO PUNCH] button.
3
The AUTO PUNCH indicator flashes and "AUTO PUNCH—REC TAKE 1" appears on
the display.
Press the [REHE] and [PLAY] buttons simultaneously.
4
The PLAY button indicator lights up, the REHE indicator flashes, and "REC TAKE 1"
disappears from the display. The Pre-roll point is located, and then playback starts. The
Pre-roll time is set using the Pre Roll function. "Setting the Pre-roll Time" on page 76
Rehearsal punch in is performed automatically at the LAST REC IN point.
5
The REHE and READY indicators light up continuously.
Rehearsal punch out is performed automatically at the LAST REC OUT point.
6
The REHE indicator goes out and the READY indicators flash.
Playback continues up to the Post-roll point at which playback stops, the PLAY button
indicator goes out, the Pre-roll point is located, and the D24 waits.
Press the [AUTO PUNCH] button to leave Auto Punch In/Out.
7
The AUTO PUNCH indicator goes out.
D24—Owner's Manual
Pre-roll
1-1 1
2-1 2
2
3-1 3
4-1 4
5-1 5
6-1 6
7-1 7
8-1 8
Locate
AUTO PLAY
REHE
PUNCH
LAST REC IN
point point
Play Rehearse
Locate
LAST REC OUT Post-roll
point point
Play